Yvonne Ellen Safari Ribbon Wallpaper Oyster Pearlised
Is it possible for a wallpaper to be sexy?!? I think the answer at this point is a resounding YES because look at this beauty! A twisted and trailing ribbon runs down the paper to give a loose stripe effect which is filled in with a classic leopard print and finished off with a pearlescent wash for a final flourish.
The design is printed on a textured ground with a pearlescent mica effect for added statement. This mural is "paste the wall" which means you do not add wallpaper paste to the back of the paper before hanging. Instead, you (or your decorator) add paste to the wall before hanging the paper onto it. Full instructions below and in the product when delivered.
Made from 49% cellulose pulp, 12% Polyester, 39% Filler/Binder/ Pigments
This roll of wallpaper measures 68.5cm in width and 10m in length.
Once hung, this wallpaper can be carefully spot cleaned with a lightly damp sponge. Don't rub too hard!
All of Yvonne Ellen's designs are greatly inspired by vintage artworks, hand drawn or painted and then lifted with a pop of pastel colour or a quirky element - sometimes both!
Before hanging check that rolls are undamaged, that numbers and letters are the same for each roll of this design and that all colours match. Return any defective roll with its label to where it was purchased. Take extra care when papering around electric light switches and power points. Do not allow moisture to drip onto electrical contacts.
Prepare wall by removing all traces of dirt, old wallpaper, or loose paint. Do not hang wallcoverings on any wall with a history of damp. Fill any cracks and allow to dry before hanging. Absorbent surfaces should be appropriately sized using a diluted wallpaper adhesive. Sealed walls, i.e. painted should be rubbed with sandpaper to create a key.
It is important that the walls are of an even and consistent colour. If they are not then consideration should be given to painting them with an appropriate colourwash. Alternatively, we recommend that walls be lined' horizontally using a good quality lining paper. Allow this to fully dry.
We recommend the use of a light ready mixed adhesive. Evenly apply the adhesive directly onto the wall using a brush or a short pile emulsion roller: It is not necessary to pre-cut the lengths of paper as it can be applied direct from the roll. Apply the wallcovering to the wall and smooth down with a good quality hanging brush or plastic spatula. Do not overlap, use butt joins.
CAREFULLY WIPE ANY EXCESS PASTE FROM THE FACE OF THE PAPER IMMEDIATELY WITH A CLEAN DAMP SPONGE BEFORE IT DRIES.
After hanging 2 or 3 lengths, inspect the results to ensure that there is no shading or other fault.